2
GB | TV Wall Mount
Gamma LED 400 (KT3344)
Safety Instructions and Warnings
Read the user manual before using the device.
Follow the safety instructions provided in the manual.
Manual can be found at: http://www.emos.eu/download
The product is designed to provide trouble-free service for many years if used properly.
• Read the manual carefully before using this product.
• Do not expose the product to excessive force, impacts, dust, high temperatures or humidity – these may cause the product
to malfunction or may deform its parts.
• Do not expose the product to rain or moisture if it is not designed for outdoor use.
• Do not disassemble, repair or modify the product. Have it repaired by the retailer you bought it from.
• Do not replace any components of the product with non-original spare parts.
• To clean the product, use a slightly moistened soft cloth. Do not use solvents or cleaning agents.
• This product may be used by persons with impaired physical, sensory or mental capabilities or persons without experience
and knowledge only if they are supervised or instructed in the safe use of the product and understand the risks that may occur.
Warning:
1. We recommend that the mount be installed by at least two people. At least one person should be technically skilled and
in good physical condition for lifting sizeable loads.
2. Please read this manual before beginning installation and make sure there are no electrical cables or water plumbing in
the spot (wall) where you intend to install the mount.
3. The manufacturer bears no responsibility for potential damage caused during installation or by improper installation and
subsequent use.
4. When in doubt regarding the correct procedure for installation, contact the nearest retailer that sells the product.
5. It is necessary to use appropriate tools and equipment during installation. Not following the instructions risks injury or
damage to property.
6. If you intend to dismount the TV from the wall, always make sure that its power cables are unplugged from the power supply.
7. If you are not certain of the load-bearing capacity of the wall you chose, choose a different suitable wall or make structural
adjustments to improve the load-bearing capacity.
8. The product is designed only for mounting TVs with a flat screen or TVs that have mounting holes and a flat back wall.
Tools required for installation (not included):
• manual Phillips screwdriver
• electric or cordless drill
• drill bit, size 10 mm (for wood or concrete, based on circumstances)
• wall plug for plasterboard or chipboard (based on circumstances)
• pencil
• water level (if not included)
• tape measure
Included in packaging:
(A) M8×63 screw with partial thread, 3 pcs
(B) 10 mm wall plug for concrete, 3 pcs
(C) M8 screw washer, 3 pcs
(D) small distance washer, 4 pcs
(E) large distance washer, 4 pcs
(F) M6 washer, 4 pcs
(G) M4×12 screw, 4 pcs
(H) M425 screw, 4 pcs
(I) M4 spring washer, 4 pcs
(J) M5×12 screw, 4 pcs
(K) M5×25 screw, 4 pcs
(L) M5 spring washer, 4 pcs
(M) M6×12 screw, 4 pcs
(N) M6×30 screw, 4 pcs
(0) M6 spring washer, 4 pcs
(P) M8×12 screw, 4 pcs
(Q) M8×30 screw, 4 pcs
(R) MB spring washer, 4 pcs
(S) M8×20 screw, 4 pcs
(T) A9 a nuts and bolts
