Page 14
BAS
X
A
-100
Application Suggestions / Examples
Manual control
The BASX A-100 is connected to a pair of speakers and receives its input from a stereo preamp.
The Trigger Switch is set to On.
The A-100 is switched On and Off directly by the rear panel AC Power Switch.
If you switch your equipment using a switched power strip, the AC Power Switch on the A-100
could also simply be left on, and the A-100 will simply turn on when AC power is applied.
Simple trigger control
The BASX A-100 is connected to a pair of speakers and receives its input from a stereo preamp.
The preamp has a trigger output, which is connected to the Trigger Input on the A-100. The AC
Power Switch on the A-100 is set to On, and the Trigger Switch switch is set to Off.
The A-100 remains in Standby mode as long as the preamp is off. When the preamp is switched
on, its trigger output becomes active, which switches the A-100 On. When the preamp is switched
off, the A-100 returns to Standby mode.
Audio signal control
The BASX A-100 is connected to a pair of speakers and receives its input from a stereo preamp.
The preamp does NOT have a trigger output. The AC Power Switch on the A-100 is set to On, and
the Trigger Switch is set to Auto.
The A-100 remains in Standby mode as long as the preamp is off. When the preamp is switched
on and starts playing, the A-100 senses the audio signal and switches On. When the signal is no
longer present, the A-100 will remain On for a few minutes, then return to Standby mode.
