Page 33
BasX MC1 Cinema Processor
Care and Maintenance
Periodic Maintenance
Your BasX MC1 requires no periodic maintenance or calibration.
Cleaning your MC1
• If necessary, the MC1 should be cleaned gently with a soft rag.
• If something sticky gets on the front panel or case of the MC1, it should be cleaned with
a mild cleaning solution applied to a soft cloth, followed by wiping with a clean cloth
dampened with plain water and drying with a soft dry rag or cloth.
Note: DO NOT spray water or cleaning solution directly onto the front or rear panel
of the MC1.
Installing Firmware Updates
From time to time Emotiva may issue firmware updates for your MC1. We strongly recommend
that you only install firmware that was downloaded from the official Emotiva website, or that you
received from Emotiva Technical Support staff.
To install a firmware update on your MC1:
1) Download the firmware file from our website or the link or e-mail attachment provided by our
Technical Support representative.
2) Place the firmware update file on a USB stick formatted with the Fat32 operating system
(any commercial USB stick formatted to work on both Apple and Windows computers should
work fine). Place the file into the main or root directory of the stick.
Note: If the firmware update is provided in the form of an archive, such as a Zip file, extract the
firmware update file from the archive onto the stick.
3) Plug the USB stick into the rear panel USB connector labelled Update.
Note: There are two different ways to initiate the firmware update. With both, once the update
starts, the front panel will display the status of the update. Depending on which method you
use, after the update completes, the MC1 may turn On or return to Standby.
4a) While the USB stick remains inserted, power the MC1 Off, allow it to remain off for twenty
seconds, then power it back On. The MC1 will recongize that a firmware update is available and
will proceed to perform the update.
4b) With the MC1 On, go into the Setup Menu, and select Setup | About | Software Update.
Select Yes when prompted whether you want to do a software update.
WARNING: *DO NOT* unplug the USB stick or turn the MC1 Off during the firmware update.
Summary of Contents for BASX MC1
