Page 15
UMC-200
12. Menu Button
Accesses the front panel menu system and the full-color on-screen display (OSD).
13. Dim Button
Press this button to dim the front panel VFD (vacuum fluorescent display) on the UMC-200.
The display will get gradually brighter each time you press the button, then, when it reaches
the brightest setting, drop back to the dimmest setting (dim but not fully off).
15. Mute Button
Press this button to mute the audio output of the UMC-200; press it again to return to the
previous Volume level.
16. Volume Buttons
Press these buttons to turn the volume up or down on the UMC-200. The current volume
setting is displayed on the front panel display.
17. Zone 2 and Zone 3 Buttons
These buttons are used to control the audio being sent to the Zone 2 and Zone 3 outputs.
When you press the Zone 2 or Zone 3 button, the remote control will temporarily control that
zone.
The display will switch to indicate that you are now controlling the selected zone; you
may then press the On or Standby buttons to turn the power for that zone On or Off (this
includes the output signal for that zone, and the trigger, if you have assigned one to that
zone); you may use the Input + and Input - to step between inputs for that zone; and you
may use the Vol + and Vol - buttons to control the audio level for that zone. The remote
control will return to normal mode (no longer controlling the selected zone) a few seconds
after you finish entering changes.
Note: The Volume and Input Selector Buttons will only accept changes while the zone
you are addressing is turned On. (When each zone is Off, the only command that it
will recognize is On.)
Summary of Contents for UMC-200
Page 1: ...umc 200 7 1 Home Theater Preamp Surround Processor User Manual umc 200...
Page 2: ......
Page 37: ...Page 32 UMC 200 Notes...
Page 38: ......