Page 19
UMC-200
You will be able to go back later and change your choice, and to manually adjust the
settings made by EmoQ if you prefer. You may also create up to three full sets of custom
manual EQ setting and choose between them. To make your new EmoQ settings active,
and apply them to your inputs, you must select EMOQ as the active EQ choice.
Note: The EQ settings stored and used by EmoQ are NOT in the same format as the
EQ settings stored in the Manual EQ storage memories. You cannot transfer the
settings stored in the EmoQ EQ configuration memory to a Manual EQ configuration
(you will end up with wildly different results), and altering the settings in the EmoQ
configuration will probably produce different results than you expect. At most, you
might wish to tailor the results produced by EmoQ by slightly raising or lowering
individual band settings to reduce or increase the overall effect of applying EmoQ.
Note: Moving the blue selector bar to an EQ choice that isn’t highlighted (bright
white) and pressing Enter selects that choice (and it goes bright white). At this point
(if you have an active input which is subject to EQ) you will be able to preview what
that choice sounds like. Moving the blue selector bar to an EQ choice that is already
highlighted (bright white), and pressing Enter, takes you into a sub-menu where you
can make detailed adjustments to the selected EQ configuration. (If you get into this
screen by mistake, and want to get out without changing anything, you can do so by
pressing Enter or Return.)
Note: If you have Direct Mode selected, or are using the 7.1 Channel Audio direct
input, you will NOT be able to preview the EQ settings (because EQ is not applied
in Direct mode). It is therefore a good idea to make sure that you are listening to an
input and mode in which EQ is applied if you want to preview your settings. (If you
haven’t done any advanced configuration, HDMI 1 or HDMI 2 will probably work well
for this.)
Note: If you run EmoQ multiple times, you will get similar results (but probably not
identical). You will not get more accurate results by running EmoQ repeatedly
(it does not save or average results from multiple runs). If you aren’t entirely satisfied
with the results, try moving the microphone to a slightly different position, or simply
adjust the results manually to fit your tastes.
Summary of Contents for UMC-200
Page 1: ...umc 200 7 1 Home Theater Preamp Surround Processor User Manual umc 200...
Page 2: ......
Page 37: ...Page 32 UMC 200 Notes...
Page 38: ......