6. Line Inputs:
Line level input should only be used if no subwoofer crossover is being
utilized through the receivers bass management.
7. LFE In:
Line level input is used to connect to most receivers or processors. The “LFE”
output of receiver and may be called “subout”.
8. Fuse Access:
This is the power fuse access.
WARNING! In the event the fuse must be replaced, the replacement fuse must
match exactly the original fuse value. If the replacement fuse is not of the same
value, damage to the Subwoofer Amplifier may result.
CAUTION!
Before replacing the fuse, disconnect the power cord from the
power receptacle.
9. Power:
Power on and off switch.
6
Subwoofer Amplifier Controls and Setup
(continued)
Subwoofer Amplifier Diagram.
