9
3. INSTALLATION PLANNING
3.1 PLAN OF ATTACK
Before you proceed to install this EMPHASER amplifier, it is recommended to map out the complete
audio system and the respective wiring required. Consider all additional electrical requirements and
accessories, such as power cables, interconnect cables and power ring terminals/battery clamps nee-
ded, to connect this amplifier. Consider i.e. a safe mounting, sufficient ventilation, convenient accessi-
bility of the fuses and the side panel controls, as well as availability of space for all peripheral system
equipment. Your work will be considerably simplified, if you have a clear idea or 'plan of attack'.
Please note that - because of possible interference problems with the existing car electrics and elec-
tronics - especially the routing of the signal cables and the chassis ground connection will have a pro-
found impact on a trouble-free operation of the amplifier.
If you have no or only little experience with complex car audio installations, we
strongly recommend you to consult your nearest authorized EMPHASER
dealer/installer.
3.2 MOUNTING LOCATION
The mounting location should be carefully selected and in the interest of passive driver and passenger
safety, the amplifier must be securely mounted. Check the suitability of your preferred amplifier loca-
tion carefully, before you start any installation attempts. Any mounting position - preferably in the trunk
compartment - that allows sufficient cooling, is okay. A good air stream across the fins of the ampli-
fier's heatsink will provide adequate ventilation and therefore improve cooling and full output capa-
bility dramatically. The air in- and outlets in the side-panels must not be covered, since they are part
of the amplifier's internal heat management by a temperature controlled fan!
Make sure there is no wiring harness, fuel tank etc. behind or below the mounting surface, that may
be damaged by the drilling of the holes for the amplifier mounting screws. After installation, there
should be a clearance of at least 5cm on all sides including the top of the amplifier heatsink. Make
sure the unit is not exposed to direct sunlight, humidity, water, oil or spill of other fluids that may enter
the amplifier.
EA 2/4-CH Manual 12.03.2002 12:54 Uhr Seite 9
