EM-MBC2
Upgrade System
for Mercedes-Benz Vehicles
Congratulations!
On your purchase of the EMPHASER 2-way system dedicated for Mercedes-
Benz vehicles. If you plan on installing this speaker system by yourself, please
read the following instructions carefully before you attempt the installation.
For any further information about this product, please contact your authorized
EMPHASER dealer.
SET CONTENT
Carefully remove the loudspeakers, crossovers and the accessories from
the gift box and check whether all parts are in good undamaged condition,
and match with the set contents listed below:
■ 1 broadband speaker
■ 1 highpass crossover
■ 1 manual
ASSEMBLY
This set is compatible with a variety of Mercedes-Benz vehicles. For step
by step instructions on how to disassemble the original loudspeakers of
your specific vehicle correctly, please contact your Mercedes-Benz service
workshop. The following instructions for the C205 model are to serve as an
example for all models.
Gently lever the center speaker cover off with a wide plastic wedge. Start at
the front and work your way to the windscreen piece by piece. The cover is
attached with clips in the places marked with rectangles.
What products are covered by EMPHASER’s limited Warranty?
The limited Warranty (the “Warranty”) applies to EMPHASER products purchased from an authorized
dealer by end customers in the European Economic Area or Switzerland (“Territorial Scope”).
What is the validity period of EMPHASER’s Warranty?
Under this Warranty, EMPHASER warrants, for a period of 2 years, that the product is free from
defects in material and/or workmanship at the time of the original purchase. This 2-year period
commences on the date of the original purchase as per the original invoice or until receipt. If you have
purchased the product as a consumer, and the defect is identifi ed within the fi rst six months after the
original purchase (see above), we will assume that the defect already existed at the time of purchase.
Who can claim under the Warranty?
EMPHASER grants the limited Warranty to natural persons only, who purchased the relevant product
primarily for personal use.
What is covered by the Warranty?
EMPHASER warrants that the product is free from defects in material and/or workmanship at the
time of the original purchase. EMPHASER does not, however, provide a warranty covering every
defect and damage that may occur. It only covers the hardware components of the device, and in no
event the software used with the device, regardless if this was provided by EMPHASER or the third-
party vendor. The Warranty therefore does not cover the following cases, in particular:
• normal wear and tear (such as to surfaces and protective coverings);
• superfi cial damage, such as scratches, dents, and damaged plastic, worn or mechanically
defective connections;
• misuse, including any treatment resulting in physical or superfi cial damage, such as a cosmetic
defect, to the product;
• damage caused by connecting or using the product for a purpose other than those specifi ed, or a
failure to observe the operating and/or installation instructions for the particular model;
• installation or use of the product contrary to the applicable technical standards, or the safety
regulations in the country in which the product is installed or used;
• damage caused through an unauthorized attempted repair, or an attempted repair by someone
other than a EMPHASER authorized service partner;
• damage caused by modifi cations to the product not expressly authorized by the manufacturer;
• damage caused by malicious code (“Software Viruses”) or by using software not supplied with the
product or which was incorrectly installed;
• use of third party vendor software programs for editing, modifying, adapting, or extending
EMPHASER’s authorized software components as are run on the product;
• use of third-party vendor fi rmware/operating system software
WARRANTY COND LIMITATIONS
The original speaker is plugged in at three points on the panel. If necessary,
use a plastic wedge to lever out the speaker. To unlock the connectors, use
either a small screwdriver or a paper clip. Connect the supplied crossover
to the original connection cable (gray / gray black) and the other end to one
of the two connection terminals of the EM-MBC1.
Connection variant 1:
If the original center speaker has two connections, you must connect the
cable for the SOS emergency call function without the included crossover,
otherwise an error message will appear in the radio display. This error mes-
sage disappears automatically as soon as the loudspeaker has been correctly
connected (i.e. without the crossover) to the SOS cable.
Connection variant 2:
If the original center has only one connection (SOS function only), you must
connect the cable for the SOS emergency call function without the included
crossover, otherwise an error message will appear in the radio display. This
error message disappears automatically as soon as the loudspeaker has
been correctly connected (i.e. without the crossover) to the SOS cable.
Connect the included crossover to the second terminal of the EM-MBC2.
Connect the other end of the crossover to the original connector.
If you use a separate amplifier for the EM-MBC2, connect the amplifier
output to the crossover as follows: If you want to keep the filter function, cut
the cable in front of the shrink tube. If you use the filter of the amplifier, cut
the wire after the shrink tube (set cut-off frequency to 200 Hz/12 dB oct.).
Stow the cables and crossovers and place the speaker on top of the three
mounting holes. Now push the speaker at the ends with the mounting balls
in the mounting holes until they are firmly locked.
Mount the cover. To do this, place the clips of the cover on the corresponding
holes and gently push the cover down until the clips snap into place.
• damage caused by liquids or chemicals of whatever type, and/or excessive temperatures, moisture,
or damp;
• accidents, drops or other such effects of extreme accelerating forces;
• damage caused by lightning strikes, electrostatic charge, incorrect operating voltage, water, fi re,
force majeure, inadequate ventilation for other reasons for which EMPHASER is not responsible;
• damage caused by using the device outside of the defi ned specifi cations;
• damage caused by using the product with other systems or devices, which are not designed to be
used with this product;
• adjustments or modifi cations without EMPHASER‘s prior written approval, including product
upgrades extending beyond the specifi cations or characteristics described in the operating manual;
• modifi cations of the product for the purpose of adapting it to national or local technical norms or
safety standards of countries for which the product was not expressly designed or manufactured;
• using service or spare parts not produced or distributed by EMPHASER;
• using the product in connection with accessories not approved for use with this product;
EMPHASER, moreover, does not warrant (expressly, implicitly, statutorily, or otherwise) the quality,
performance, reliability or suitability of the product for a particular purpose except as described, nor
the software/fi rmware installed on the device ex works.
No warranty service will be provided, moreover, if the model number
/serial number/UUID/product number on the product is changed, erased, made illegible or removed. The
same applies if the receipt or invoice is incomplete and/or illegible when presented.
Is EMPHASER liable for other defects or damage?
EMPHASER will repair or replace products, only if they are covered by the terms of this Warranty.
EMPHASER is not liable for any material or intangible loss or damage such as the price paid for the
product, loss of profi ts, revenue, data, or relating to the enjoyment of the product or components
associated with it, arising directly or indirectly under this Warranty or otherwise in relation to products
or services. This likewise applies to loss or damage relating to the impairment or operational failure
of the product, or devices associated with it, caused by defects or the non-availability of the product
during the time it is with EMPHASER or EMPHASER’s service partner, as well as to periods of downtime
and business interruptions. In addition, EMPHASER does not accept any liability for shipment-related
risks - such as the loss or destruction of the product - in connection with the fulfi lment of the Warranty.
This disclaimer applies to losses of damage irrespective of the legal basis, especially on the grounds
of negligence, other wrongful conduct (torts), breach of contract, express or implied guarantees, and
strict liability (even if EMPHASER or its service partner has been advised of the possibility of such
damage occurring).
If these disclaimers are prohibited or limited under the applicable law, EMPHASER will limit its Warranty
and liability to the extent permissible under the applicable regulations. For example, some national laws
prohibit the exclusion or limiting of damages payable in connection with negligence, gross negligence,
willful wrongdoing, deceitful conduct, and other such acts. For the duration of this Warranty, all liability
that cannot be excluded completely will be limited to the extent permissible under the applicable law.
Liability under this Warranty is limited to the price paid for the product. If the applicable law only permits
higher limits on any liability, this higher limitation will apply.
How do I exercise my Warranty rights?
If you want to exercise your entitlements under this Warranty, please contact the authorized dealer
where the product was purchased, and present it with the original copy of the till receipt or invoice. Do
not return any products to EMPHASER directly, otherwise our Warranty obligations cannot be fulfi lled.
You will fi nd the name of the relevant dealer or reseller on your proof of purchase.
Defective devices sent by the authorized dealer to the service center, must also be accompanied by any
accessories with a logical connection to the observed fault. This means, for example, the navigation
package on an SD or microSD card supplied or purchased with the device, if problems or functional
errors were observed in connection with the navigation function.
How will EMPHASER fulfi l its Warranty?
EMPHASER or its service partner will choose to either repair or replace the product or its defective
parts covered by the Warranty, and assume the costs of material and labor in doing so.
Repairs under the Warranty must be carried out by EMPHASER or its authorized service partner.
Products that are repaired or replaced may contain new and/or refurbished components and devices.
Components that are swapped out will become the property of EMPHASER.
Will I incur any costs in connection with the Warranty service?
EMPHASER assumes the costs of material and labor in connection with its Warranty service. The
Warranty holder is responsible for the costs of shipment and bears the risks connected with the shipment
(see above). If the product is found to be operating faultlessly, or there is no warranty entitlement
because the warrant period has expired or for any other reason, EMPHASER or its authorized service
partner will be entitled to charge a fl at-rate investigation fee of €30.00.
Do this Warranty affect my statutory or contractual rights?
This Warranty is made voluntarily by EMPHASER, and it will, in any case, extend your statutory rights.
As a consumer, you remain fully entitled to your statutory rights, such as the statutory guarantee.
This Warranty also has no effect whatsoever on your contractual rights against the reseller. You may
continue to exercise these rights in full.
Proper installation confirmed by the following authorized EMPHASER dealer:
Korrekte Installation bestätigt durch folgenden autorisierten EMPHASER Händler:
