26988-3-1012
Page 28
Before you begin: if you are installing logs into the ADVD32 OR
ADVD36 model then this fireplace is supplied with a set of five
ceramic fiber logs. Do not handle these logs with your bare hands!
Always wear gloves to prevent skin irritation from ceramic fibers.
After handling logs, wash your hands gently with soap and water
to remove any traces of fibers.
The positioning of the logs is critical to the safe and clean operation
of this fireplace. Sooting and other problems may result if the logs
are not properly and firmly positioned in the fireplace. Please refer
to Figure 46 and Figure 47 and corresponding
WARNING
when
completing following log placement instructions.
1. Remove top louver, grasp louver, lift and pull forward.
2. Lower bottom louver, lift and hinge forward.
3. Release two glass frame spring clamps at bottom of firebox.
4. Remove glass frame assembly.
5. Place front logs (#1 and #2) between front grate flange and
main burner. Align notches on front logs with locator tabs in
base.
6. Place middle log (#3) between front and rear loop of burner.
Note: Do not place log on top of pilot assembly.
7. Place rear log (#4) on rear log shelf. Bottom flange of log must
be placed between the log shelf and burner tube.
8. Place branch (#5) onto (#1) log and flat area on (#3) log. The
bottom of the branch is to be placed behind the grate tang that
is second from the left.
9. Place decorative rock in front of grates and sides of main burner
pan.
ATTENTION:
Do not place decorative rock on logs or burner.
The decorative rock should only be placed on the fireplace
floor.
EMBER MATERIAL PLACEMENT ON BURNER
10. After all logs are positioned properly, apply Rockwool ember
material to the front burner port area. To apply, carefully separate
the ember material into small amounts no larger than "dime
size" pieces. Fluffed up pieces one layer thick on top of the
burner generally works best, and will provide the best ember
glow. Do not place ember material more than one layer thick. No
more than (1) small packet of ember material (part no. 15999)
evenly placed on the burner, is recommended on ADVD32 and
ADVD36 models. Using additional ember material will decrease
the amount of ember glow effect. Extra ember material should
be saved for future ember applications as necessary.
See Figure 48.
11. Replace glass frame onto firebox.
12. Secure the two glass frame spring clamps at bottom of
firebox.
13. Align the tabs on top louver brackets with slots in front posts
to secure top louver.
14. Close bottom louver. Lift slightly to engage the end tabs into
the slots in fireplace sides to close louver panel
1
4
5
3
2
Figure 47
WARNING:
Failure to position the parts in accordance with
this diagram or failure to use only parts specifically approved
with this appliance may result in property damage or personal
injury.
Attention: Do not use Figure 47 or Figure 48 to order logs. Refer to
parts list on page 35 and parts view on page 36 to order logs and/
or ember material for your appropriate fireplace model.
1
2
3
5
4
EMBER MATERIAL
PLACEMENT
Figure 48
LOG PLACEMENT (5 LOG SET)
