Page 3 of 35
Metering Pumps
Operating and Maintenance Instructions
www.empirepumps.com
Once the packaging has been removed, check the pump, and if in doubt do not use the pump and
consult with qualified personnel. The packaging materials (such as plastic bags, polystyrene, etc..) must
not be left within reach of children as they are potential sources of danger.
Before connecting the pump, make sure that the data on the plate corresponds to that of the power
distribution network.
The nameplate data is shown on the adhesive label attached to the pump.
PLEASE NOTE:
•
The equipment is made to perfection. Its durability, electrical and mechanical reliability will be
enhanced if it is correctly used and undergoes regular maintenance.
•
The equipment is supplied with the earth on the power cable. It is recommended to always connect it
to an earthing system that is up to standard and equipped with a circuit breaker.
The electrical installation must comply with the rules in force in the country where it is installed. The use
of any electrical device requires compliance with some basic rules. In particular:
- do not touch the equipment with wet or damp hands or feet;;
- do not handle the pump with bare feet (typical situation: units used in swimming pools)
- do not leave the unit exposed to the elements (rain, sun, etc.) ;
- do not allow the pump to be used, serviced or cleaned by children or by people without adequate
training and without supervision.
WARNING:
•
Any intervention or repair within the equipment must be carried out by qualified and authorised
personnel. We disclaim all responsibility as a result of non-observance of this rule.
•
This equipment must NOT be used by: children, people with impaired physical, sensory or mental
capabilities, inexperienced personnel, unless they are supervised or instructed on the appropriate use
of the unit by a person responsible for their safety.
•
In case of failure and / or malfunction of the pump, turn it off and do not tamper with it. For any
repairs please contact our service centres and request the use of original spare parts. Failure to comply
with the above may compromise the safety of the pump.
•
If you decide to no longer use an installed pump it is recommended to make it inoperative by
disconnecting it from the power supply and emptying the pump body.
•
If there are leaks from the hydraulic part of the pump (breakage of seals, valves, pipes), you must
stop the operation of the pump, depressurise the discharge pipe and proceed with maintenance using
appropriate safety measures (gloves, goggles, overalls, etc.).
•
In case of failure and/or malfunction of the pump, turn it off and do not attempt to repair it. For any
repairs please contact our after-sales service centres and request the use of original spare parts.
