change to red, and you are now able to select Mode 3. Press it
again and the
in 2
LED will be lit green, and you are now able to
select Mode 4 etc. This pattern continues until you reach Mode 12
and then starts over again at Mode 1.
To configure an external switch
(momentary - normally
open), use the
stomp function
toggle switch. Set it to the left
position (Boost) to use an external switch as a boost. Set it to the
right position (AY) to use an external switch as an instant silent
tuning switch. The middle position (AB) is for no external switch.
The red "tuner on" LED will flash each time you change the switch
position to show you it has registered a change.
To save your settings and exit Startup Configuration
,
hold down the stomp switch for 2 seconds. The blue boost LED will
flash quickly, followed by the corresponding mode LED to
acknowledge your selection. The Stereo will now enter your
selected mode every time it starts up, unless you change it again by
going back into the Startup Configuration.
Summary of Contents for buffer plus
Page 1: ...user manual...
