1 Pre installation
2 Components
3
Part no Product description
EC-41-0200
EMS Wireless Zone Interface Module
Zone Interface Module
Installation Guide
IDENT REV DATE
FC-610-001 EN300 200-2
0905
!
20K
4K7
C
N/O
20K = Red/Bl
4k7 = Yellow
EOL Resistor
Configuration
ANTENNA
2
1
4 Remove cable entry points
5 Fix
to the wall
Drill the cable entry
points as necessary.
Cable glands should
be used.
DO NOT leave excess
cable in the device.
ON
INPUT 1
INPUT 2
EXPAN1
EXPAN2
OUTPUT 2
OUTPUT 1
IP- IP+ IP- IP+
3VDC SET RS
T
N/O COM
N/C
3VDC
SET RST
N/O COM
N/C
DO NOT use
=
Available
cable entry
points
=
3 Mounting location guidelines
Ensure the ZIM is not installed
within 2 m of the control panel
or any other wireless or
electrical equipment.
Ensure the ZIM is not installed
within 0.6 m of any metal work.
Ensure the ZIM is not installed
within 0.6 m of the WZM.
WIRELESS ZONE INTERFACE MODULE
WZM
ZIM
0.6 m
Existing
control panel
WZM
ZIM
0.6 m
POWER
FAULT
WIRELESS ZONE MONITOR
2 m
WIRELESS ZONE INTERFACE MODULE
WIRELESS ZONE INTERFACE MODULE
POWER
FAULT
WIRELESS ZONE MONITOR
Existing
control panel
FIRE
Fire Alarm Control
FIRE
Fire Alarm Control
!
Installation must conform to applicable local installation
codes and should only be installed by a fully trained
competent person.
Ensure that the device is installed as per the site survey.
The use of a non-metallic spacer should be considered if
mounting the device on to a metal surface.
DO NOT press the log on button on a pre-programmed
device, as this will cause communication with the control
panel to be lost. Should this happen, delete the device from
the system and add it back on.
This device contains electronics that may be susceptible to
damage from Electrostatic Discharge (ESD). Take appropriate
precautions when handling electronic boards.
4x lid fixing screws
Front lid
Back box
1
2
3
For optimum wireless
performance, the
following must be
observed:
Use all four circled
fixing positions to
ensure a firm fixing.
Use suitable fasteners
and fixings.
ANTENNA
KEEP CABLES AWAY FROM THIS AREA
LOGON
OUTPUT
2
OUTPUT 1
3VDC SET RST
INPUT 1 INPUT 2
LED
ENABLE
POWER
INPUT
INPUT
FAULT
CLOSED
0
1
1
64
F-SAFE
N/O COM N/C
IP- IP+ IP- IP+
3VDC SET RST
N/O COM N/C
EXPAN1
EXPAN2
RELA
Y ON
RELA
Y ON
2
4
8
16
32
ON
1 2 3 4 5 6 7 8
012ABC
Fixing position
location within
cavity
©2021 EMS Ltd. All rights reserved. Page 1 of 2
TSD142-99 Iss 6 15/12/2021 AJM
