www.emsgroup.co.uk
Radio Detector Base
PRESS HERE TO
LOG ON
IDENT
63mm
1
Pre Installation
4 Power Device
3 Fix Mounting Plate
2
Components
device
unpowered
(pins unlinked)
device
powered
(both pins linked)
!
Installation must conform to applicable local installation
codes and should only be installed by a fully trained
competent person.
Ensure that the device is installed as per the site survey.
The use of a non-metallic spacer should be considered if
mounting the device on to a metal surface.
Do NOT Press the Log On button on a pre-programmed
device, as this will cause communication with the Control
Panel to be lost. Should this happen, delete the device from
the system and add it back on.
Remove the mounting plate from the wireless module by turning
it anticlockwise.
Use both mounting holes to ensure a firm fixing.
Use suitable fasteners and fixings.
Once powered, reassemble the device.
Wireless Detector
Installation Guide
FCX-170-001 Wireless Detector Base Only
[3]
FCX-174-001
Multisensor Smoke Detector Only
[4]
FCX-175-001
Heat A1R Detector Only
[1]
FCX-176-001
Heat CS Detector Only
[1]
FCX-177-001
Optical Smoke Detector Only
[2]
Example shown:
FCX-177-001
FCX-170-001
Part No Product Description
See the Specification section for compliance information.
CPR
SIZE AA
SIZE AA
SIZE AA
SIZE AA
SIZE AA
SIZE AA
ATTENTION
OBSERVE PRECAUTIONS
FOR HANDLING
ELECTROSTATIC
SENSITIVE
Detector
Wireless Module
2
3
Dust Cover
1
Unclip the battery retaining plate from the wireless module.
When fitting / replacing batteries; observe correct polarity,
using only specified batteries.
Connect the power jumper across the PIN header.
The detector can also be
locked into the wireless
module. To do so, prior to
refitting the detector, remove
the cut out (shaded) section
as shown.
5 Optional Device Locking
To lock the wireless module
into the mounting plate, insert
a 1.5mm Allen key into the
allen key slot and turn
clockwise as shown.
To unlock the wireless module
from the mounting plate,
insert a 1.5mm Allen key and
turn anticlockwise to release
as shown.
6 Device Unlocking
To unlock the detector from
the wireless module, insert a
1.5mm Allen key and lever the
Allen key towards the outside
of the device whilst turning the
detector anticlockwise to
release as shown.
©2020 EMS Ltd. All rights reserved Page 1 of 2
TSD044 Iss 14 14/10/2020 AJM
ww
w.emsg
roup
.co
.uk
Radio D
etec
tor Base
PRESS HERE T
O
L OG ON
IDENT
w
w
w
.emsg
r
oup
.c
o
.uk
R
adio D
et
ec
t
or Base
PRESS
HERE T
O
L
OG ON
IDENT
2
3
4
1
5
4
Battery Retaining Plate
Mounting Plate
5
