Manual-EMT-PRO-Tonearm
6/13
Installing the Tonearm
1.
Use the 2mm Hex key wrench to move the retaining-screw into the
correct position. The screw must not protrude into the hole. Refer to
picture 1B for correct position.
2.
Insert the Tonearm into the Base-ring. The groove in the shaft should
be aligned with the retaining-screw. Refer to the orange markings in
picture 2.
3.
Carefully tighten the retaining screw. Make sure the bolt of the screw
fits into the groove as shown in picture 3.
1A
1B
2
3