Manual-EMT-PRO-Tonearm
7/13
Tonearm Wiring (Standard)
In the standard configuration, your tonearm is delivered with wire outlet
thru the shaft. The five wires shall be soldered to an existing connection
terminal integrated in your turntable. Please ask your dealer for support.
Colour assignement:
-
Red = Right Hot
-
Green = Right Cold
-
White = Left Hot
-
Blue = Left Cold
-
Black = GND
DIN Output Connector (Option DIN)
As an option, your tonearm is delivered with a 5-pin DIN-connector. If
required, the axial orientation of the connector can be changed according
the procedure below:
1.
Remove the six countersunk head screws holding the DIN adapter.
2.
Carefully turn the DIN-adapter into the required position. Make sure
not to pull the internal wiring.
3.
Insert the six countersunk head screws again and tighten them care-
fully.
Warning:
To prevent damage to the sensitive bearing unit, do not release any other
screw except the six ones indicated in the drawing (green circle).
