11
Getting Started
Before using the S3 BTGPS Receiver, the following tasks must
be completed:
install a GPS/Mapping application software properly and
completely on the host device.*
enable Bluetooth on the host device.*
fully charge the S3 BTGPS receiver.
* For information about the operation of the host device and GPS/Mapping
application software installation procedures, please refer to the
documentation that accompanies each product respectively.
1. Turn on the power of the S3 & host device.
►
Turn on the power of the host device and prepare for connection.
►
Turn on the power of the BTGPS, the power switch is indicated as “B” in Figure 2.
(Make sure the battery of the BTGPS is fully charged.)
Once the S3 is powered-on and before being paired/connected, the LED indicator
lights should look like this:
LED Indicator
Symbol
Status Indication
BLUE
Flashing one time every second
GREEN
Constant on (i.e. no fixed position)
ORANGE/RED
No light (if fully charged)
Switch to power-on
position:
“
”
Status LED Indicators:
Blue
Green
Orange
/
Red