14
Frequently Asked Questions
Which GPS/Map application software can I use?
There are a lot of major application software packages available. The S3 will
work with any mapping software that uses the industry standard NMEA
messages.
Can I use the Crux-View for navigation purpose?
No. The Crux_View Test Program is only for evaluation and for testing purposes
only; it is NOT designed for navigation.
What is the passkey or pin code for the
S3
paring with the PDA?
Please key-in: 0183. This the passkey or the pin code required.
I already paired the
S3
BTGPS Receiver with the PDA, but sometimes it
just cannot connect to the
S3
.
Delete the ‘old
BTGPS
icon’ on your Bluetooth manager software, and re-search
and pair it again.
It is possible to charge the battery and at the same time use the
S3
?
Yes. This means you can have continuous use of the S3 BTGPS Receiver.
The GPS program is not showing my location.
If the green light on the S3 is flashing, check to see that you have the correct
COM port and baud rate selected (4800-38400) and that your device is paired
with the S3. If the green light is not flashing, position the receiver so that it
has an unobstructed view of the sky. If the green light is not flashing after
being outside for more than fifteen minutes, please contact technical support.
The green light on my S3 BTGPS will not come on.
Remove the unit from external power source. Turn unit on and let the
batteries drain for 24-48 hours. After 24-48 hours, fully charge the S3 and
turn on. If green light is still off, please contact Technical Support for more
information.
The blue light on my S3 BTGPS will not come on.
Please contact Technical Support for more information.
Additional FAQ, technical support and
new product information can be found at
www.EMTAC.com
.
