Emtek Keypad Deadbolt Locksets, Installation & Programming Manual

10

How to Program

Programming Your Lock

In order to perform each of the following six functions, the lock must first be 

placed in Programming Mode:

*If no input within 10 seconds, Yellow LED goes out, Red LED flashes and lock exits Programming Mode.

1.  Press and hold EMTEK button for 3 seconds

2.  Yellow LED flashes, then remains solid*

3.  Enter Programming Code 

4.  Green LED flashes, then 1 beep

5.  Yellow LED remains solid (awaiting button press; see following Table)

I

f

you

wIsh

to

P

ress

B

utton

A

ctIons

I

ndIcAtors

Change  

Programming 

Code

(6 digits)

1

Enter New 

Programming 

Code

(6 digits)

Re-Enter 

New 

Programming 

Code

(6 digits)

• 1 Green LED flash 

• 1 beep 

• 1 Green LED flash

• 1 beep

• 2 Green LED flashes

• 2 beeps

Add User Code

4 digits

(Store up to  

20 User Codes)

2

Enter New 

User Code

(4 digits)

Re-Enter  

New User 

Code

(4 digits)

• 1 Green LED flash 

• 1 beep 

• 1 Green LED flash

• 1 beep

• 2 Green LED flashes

• 2 beeps

Delete User Code

3

Enter User 

Code to be 

Deleted

Re-Enter 

User Code to 

be Deleted

• 1 Green LED flash 

• 1 beep 

• 1 Green LED flash

• 1 beep

• 2 Green LED flashes

• 2 beeps

**

Enable/Disable 

All User Codes

4

Entering ‘4’ disables all Users 

(enables all if disabled)

• 2 Green LED flashes

• 2 beeps

Delete All User 

Codes

5

Re-Enter Programming Code

• 1 Green LED flash

• 1 beep

• 2 Green LED flashes

• 2 beeps

Turn Beeper On/

Off

6

Entering ‘6’ turns OFF (or ON)

• 1 Green LED flash

• 1 beep

• 2 Green LED flashes

• 2 beeps

**Also referred to as “vacation mode”. This command temporarily disables all user codes (metal key 

override will still work).