LightPulse LP850 Fibre Channel PCI Host Adapter Manuals Page 9 of 10
Copyright Emulex Corporation - All rights reserved, 1999
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
l
Reorient or relocate the receiving antenna.
l
Increase the separation between the equipment and receiver.
l
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
l
Consult the dealer or an experienced radio/TV technician for help.
The reader is cautioned that any changes or modifications to the equipment not expressly approved by Emulex
could void the user’s authority to operate this equipment.
This class B digital apparatus meets all requirements of the Canadian Interference - Causing Equipment
Regulations. Cet Appareil numerique de la classe B respecte toutes les exigences du reglement sur le material
brouilleur du Canada.
The above statement applies to products marketed in Canada.
VCCI Notices and Translations (Japan Only)
Note
VCCI regulations provide that changes or modifications
not expressly approved by Emulex Corporation could
void your authority to operate this equipment.
Models LP850-T1/N1 (GBIC Models)
This is a Class B product based on the standard of the Voluntary Control Council for Interference by
Information Technology Equipment (VCCI). If this equipment is used near a radio or television receiver in a
domestic environment, it may cause radio interference. Install and use the equipment according to the
instruction manual.
Model LP850-D1 (Embedded Copper Model)
Product Label
