INSTALLATION AND CONNECTION
54
smart Econ - emz-HCW - 180116
4-pole CAN bus line
The first device on the CAN bus line must be smart Econ HCW.
(The CAN bus of the
smart Econ HCW is already factory terminated, the terminating resistor is permanently installed.
A jumper must be inserted on the last device of the CAN bus line.
It is irrelevant at which device
the bus line ends.
Avoid junctions!
Example:
Tip:
Never connect more than two cables under one terminal, and only one cable may be connected
between two devices at a time.This automatically results in a serial cable routing.
Termination in 1st device:
smart Econ HCW
NO jumper
Set the jumper
on the last
device on site!
