ELECTRICAL CONNECTION
44
smart Stove - 0142 - 42WMSUGAT2-C
Electrical connection
Terminals
The differential temperature controller smart Stove is connected by four three groups of spring-type
terminals which are visible once the terminal cover is opened.
To introduce the cables, release the three screws on the strain relief device; if necessary, remove
the strain relief device.
In case of flush mounting of the cables, the break-out segments in the housing base can be
removed carefully and the cables routed through these ports.
The central terminal block is the interface to a potential-free change-over contact - here, it may be
necessary to route electrical resistors into the spring-type terminals and to connect part of the
cables via luster terminals.
DANGER
Electrical hazard
Lethal danger due to electrocution!
Whenever work is performed on the open terminal cover, all
poles of the power supply must be disconnected reliably and
protected against being switched on again!
Terminal block
TS1-TS4
Terminal block
TS5-TS8
Terminal block
REL
Terminal block
RO2/RO1/Power
