DESCRIPTION
smart Stove - 0142 - 42WMSUGAT2-C
9
Description
The differential temperature controller smart Stove is an independent electronic controller for con-
trolling heating and water temperatures for use with hydrophilic wood log and pellet stoves in combi-
nation with one or more buffer tanks.
The controller is equipped with a robust three-part plastic housing which can only be opened by
means of tools (screw driver PH2).
Operation is effected by means of only two control elements; indications appear against a backlit
colour display.
Scope of supplies
• Differential temperature controller smart Stove
• Operating Instructions
Mounting and connection
Before connection of the electrical system, the controller must be mounted firmly to a perpendicular,
robust surface (wall), see “Mounting” on page 40.
For its own supply and the supply of the outputs, the controller must be connected to an electrical
energy supply system in accordance with the technical data, see “Electrical connection” on page 44.
Assembly, connection, commissioning, repair and disassembly of the controller are only admissible
in a specialist workshop.
Each temperature sensor has two connectors which are equivalent, i. e. interchangeable. Thus,
polarity reversal is not an issue.
The sensor lines can be extended up to a length of 100 m, to this effect, a cable cross section of
2 x 1.5 mm
2
is recommended.
DANGER
Loose installation or connection
Lethal danger due to electrocution!
Whenever work is performed on the open terminal cover, all
poles of the power supply must be disconnected reliably and
protected against being switched on again!
NOTICE
To ensure correct operation, temperature sensors type Pt 1000
must be used - the sensor design does not affect function.
