ENANCER Electrónica Lda
Page 3 of 9
Rua Max Grundig 9
4705-820 Braga Portugal info@only-smartbuildings.com
Tel: +351 253 221 484 www.only-smartbuildings.com
DESCRIPTION
The D-FTC2E is a Gateway that enables the connection of the ONLY BUS to an ETHERNET network allowing the remote
control of the installation via the Internet.
It has to be connected to a Router by a RJ45 10/100 Base T Jack.
INSTALLATION
Using your mobile device, you should install the free ONLY / Everfid application available on the App Store, or
App Only / Welink on Google Play (
http://www.only-smartbuildings.com/pt/application/
)
The D-FTC2E should be in learning mode for all installation modules by pressing the PROG key for 5s until the 2
red LEDs flash. This operation takes more or less time depending on the number of modules in the installation.
In order to make easier the identification of the module in a network, from the V2.3 version every D-FTC2E have a
static IP address with the following network settings:
IP address: 192.168.1.60;
Subnet mask: 255.255.255.0;
Gateway: 192.168.1.1.
If it is necessary to change these definitions, connect your PC directly to the module with a network cable, open
an internet browser and enter the configuration page of the module’s ethernet interface.
Note: From version 2.5 onwards it is necessary to use a specific configuration software for the module's ethernet
interface that you should request from ONLY. Open the ONLY application on your mobile device, enter the IP
address get above and port number 1470. In the next step, before pressing the register button, you must enter an
8 digit PIN on keys 1...4 of D-FTC2E.
Note: The first time you set the PIN, it must be entered twice in a row.
Summary of Contents for ONLY SMART HOME D-FTC2E
Page 1: ...BUS Networking User Manual...