VIBRATING PLATES
13
PEN10B-PEN13C-PEN16C-PEN16D
en
6.3 OPERATION
6.3.1.
The accelerator lever, located on top of the handle, controls the operation of the roller.
Apply the accelerator lever from idling position until the accelerator comes to a limit.
When the engine speed reaches 2,300 RPM approximately, the centrifugal clutch is
engaged. If the engine speed increases very slowly, it might be because the clutch is
slipping. Do not apply the accelerator lever slowly.
6.3.2.
When working with the plate, the trigger fixing the grip should not be activated.
6.3.3.
The water system will provide about 20 minutes’ spraying with the water cock completely
open and the roller working at full speed (optional).
We recommend mixing a small amount of detergent or diesel fuel with the water, to make it flow
more easily.
6.3.4.
To compact asphalt, we recommend impregnating the underside of the vibrating plate
with diesel fuel. This will help stop the plate from sticking to the asphalt.
6.3.5.
Dampening plate, reference ENARCO C0028, is foreseen for compacting cobblestones,
to prevent causing damage to the cobblestones.
6.3.6.
To suppress the vibration, quickly shift the lever from the ON to the OFF position..
6.4 STOPPING THE ENGINE
6.4.1.
Before stopping the engine, leave it idling for 2-3 minutes and then press the stop button
until the engine comes to a complete standstill.
6.4.2.
Close the fuel cock.
6.4.3.
If the water system has been used, close the water reservoir cock.
!
