FRECUENCY CONVERTER AND POKERS
7
en
ROCKET
2V 38, 2V 50, 2V 60, 1V 38, 1V 50
working conditions and the work to be performed
. Use of the power tool for operations
different from intended could result in a hazardous situation.
5)
Service
a)
Have your power tool serviced by a qualified repair person using only identical
replacement parts
. This will ensure that the safety of the power tool is maintained.
.
SPECIFIC SAFETY RULES
For the proper operation of the converter, MAKE SURE that operators have been instructed in the proper
management of this machine.
The converter SHOULD ONLY BE USED in the specific jobs.
Before connecting the converter to the electrical system, MAKE SURE that the voltage and frequency
coincide with the ones stated in the characteristics equipment name plate, located on the bottom of the
machine.
ENSURE that all box screws are tight before starting work.
Be sure that the parts of the poker are tight before starting work (welding points).
The plug should not be used to start or stop the equipment.
AVOID the flattening of the cable by heavy machinery which could cause breakage.
Keep the converter clean and dry.
Make sure that the electrical cable extension is with the proper section and functioning properly.
Before doing any work of maintenance, disconnect the motor from the electrical system.
When connecting to a generator, make sure that the out tension and frequency is stable, right and has the
proper power. (the feeding voltage should not vary than +/- 10% as stated on the converter plate)
The level of acoustic pressure is less than 80 dB (see table point 2). Proper protective equipment should be
used.
The vibration that transmits to the operator does not exceed 2,5m/s
2
of acceleration. See table in point 2.
The vibrating pokers should not be working out of concrete more than 5 minutes.
When finishing the job or when taking a break, the operator should switch off, disconnect it from the electrical
system, place it in a such way that should not fall or tip.
IN ADDITION, LOCAL COUNTRY STABLISHED ORDINANCES SHOULD BE RESPECTED.
