AVMU MOTOR - FLEXIBLE SHAFT AND POKERS
6
AX25, AX32, AX40, AX48, AX58 - AVMU
TAX1m, TAX1-5m, TAX2m, TAX3m, TAX4m, TAX5m, TAX6m -
AVMU
en
CHECK for misalignment or binding of moving parts, breakage of parts, and any other condition that
may affect the tools operation.
If damaged, HAVE the tool serviced before using.
USE only accessories that are recommended by the manufacturer for your model.
4.5 SERVICE
Tool service MUST BE PERFORMED only by qualified repair personnel.
When servicing a tool, USE only identical replacement parts.
FOLLOW instructions in the Maintenance section of this manual.
4.6 SPECIFIC SAFETY RULES
For the proper operation of the motor, MAKE SURE that operators have been instructed in the
proper management of this machine.
The motor SHOULD ONLY BE USED in the specific jobs for with it the help of this manual.
Before connecting the motor to the electrical system, MAKE SURE that the voltage and frequency
coincide with the ones stated in the characteristics equipment plate, located in the top part of the
plastic housing.
DO NOT WORK CLOSE To flammable liquids or in areas exposed to flammable.
ENSURE that all frame screws are tight before starting work.
TO AVOID the flattening of the cable by heavy machinery with could cause breakage.
DO NOT CONNECT THE FLEXIBLE SHAFT TO THE MOTOR WHEN THIS IS WORKING.
DO NOT OPERATE in the motor shaft when this is working and without transmission.
DON NOT WORK with transmission or poker in bad conditions, the motor overheats.
DO NOT WORK with the plastic housing broken.
DO NOT PERMIT untrained personnel to operate the motor or connections.
MAINTAIN free ventilation of air.
KEEP the motor in a clean and dry area.
The motor plug should not be used to start stop the equipment.
The electrical feeding cable should not be used to remove the plug from the socket.
MAKE SURE that the electrical cable is with the proper section and functioning properly.
Before doing any type of repair, DISCONNECT the motor from the electrical system.
When connecting to a generator, MAKE SURE that the out tension and frequency is stable, right,
and has the proper power, (the converter’s feeding voltage should not vary more than ± 5% as
stated on the motor’s plate).
When finishing the job or when taking a break, the operator SHOULD UNPLUG, disconnect it from
the electrical system, and have it placed in such a way that it should not fall or tip
4.7 PERSONAL PROTECTIVE EQUIPMENT
Use approved protective equipment. Operators and all other persons in the working
area must wear protective equipment:
Helmet, hearing and eye protection, gloves and boots.
