Battery Installation
The enbrighten™ Vintage Series LED Lantern requires
4 AA batteries. If replacing used batteries, remove the
old batteries and follow the instructions here:
Hanging the Lantern
The lantern can be hung securely with the built-in
carabiner hook located under the base.
If the lantern has been
mounted*
, the battery install
and replace steps are the
same. It is not necessary
to unmount the base to
replace batteries.
BATTERIES MAY LEAK HARMFUL LIQUIDS OR IGNITABLE
MATERIALS OR EXPLODE CAUSING INJURY OR PRODUCT
DAMAGE.
• DO NOT MIX OLD AND NEW OR OTHER BATTERY TYPES
• REPLACE ALL BATTERIES AT THE SAME TIME
• REPLACE FULLY DISCHARGED BATTERIES IMMEDIATELY
• REMOVE BATTERIES IF PRODUCT IS TO BE UNUSED FOR
EXTENDED PERIOD OF TIME
1. Grasp the lantern with
both hands and carefully
twist the base counter-
clockwise to remove it.
This reveals the battery
compartment of
the lantern.
1. Carefully release the
carabiner hook from its
recessed storage location.
2. Press the latch, and clip
the carabiner onto a sturdy
fastener or tree branch.
Spring-loaded latch must
close completely to be
secure.
Lantern is suitable for indoor/
outdoor use. Always be sure
to hang the lantern in a safe
and secure area.
2. Insert four AA batteries,
noting the polarity markings
located inside the battery
compartment.
3. Replace the lantern base
by aligning it with the body
(position the enbrighten
logo just right of the power
switch) and giving a small
clockwise twist to secure.
USB Power Option
The lantern can be operated with a
micro USB
cable
and
USB charging accessory†
to conserve
battery life (battery bypass). It can also be run
entirely without batteries in this configuration.
Plug in to
conserve
batteries!
†Micro USB cable and USB
power/charging accessories
are not included.
Minimum
5V@1.0A charger required.
The micro USB port DOES
NOT charge the lantern or USB
devices, it only provides an
alternative power option for
the lantern.
IP44 (splash) rated for
water resistence. DO NOT
leave lantern out in rainy
conditions.
Lantern should never be
left out in excessive wind.
Lantern cannot be
permanently installed
outdoors.
*See back page
for mounting
instructions and
template.
• USB POWER OPTION SHOULD NOT BE USED AS A PERMANENT
INSTALLATION.
• USB POWER INPUT SHOULD BE USED IN DRY LOCATIONS ONLY.
• ONLY USE UL LISTED 5V@1A USB CHARGER TO OPERATE THE
LANTERN IN BATTERY BYPASS MODE.
• DO NOT USE USB CABLE WITH FRAYED WIRES, DAMAGED CORD,
OR DAMAGED CONNECTORS.
• DO NOT RUN USB CABLES UNDER RUGS, PILLOWS, CUSHIONS,
OR BEHIND CURTAINS.
• DO NOT USE USB INPUT IF THE RUBBER GUARD IS BROKEN
OR MISSING.