Harmony Gateway Basic User Manual
24
SNMP TAB
The SNMP tab allows your Gateway Basic to be configured for use in an SNMP-based network. Note that you
must activate the
Enable SNMP Operation
option by clicking the checkbox to configure SNMP settings.
The settings specific to SNMP operation are described below:
•
SNMP General Setup
– Allows you to set up general SNMP settings
o
Read/Write Community Name
: The name (or string) that permits access to device information
o
Trap Version
: Select the SNMP version(s) of the trap messages generated from your Gateway Basic
o
Trap Manager Host IP
: IP address of your Trap Manager software
o
Trap Community Name
: string included when Gateway Basic sends Traps to your Trap Manger
software
•
SNMP V3 Setup
– Allows you to set up settings specific to SNMP V3
o
User Name
: Login name to access your Gateway Basic’s SNMP information
o
User Authentication Level
: Select the level of security desired for the SNMP network
o
Authentication Password
: Password used to confirm user identity
o
Privacy Password
: String used to encrypt SMNP V3 messages
