Encore Networks EN-4000, Reference Manual

For information on trademarks, safety, limitations 
of liability, and similar topics, see 

http://www.encorenetworks.com/disclaimer.htm

. 

Go to Table 

of Contents

Setting the EN-4000’s Modem 

to Use AT Commands

his document describes how to set the EN-4000’s modem for use of Hayes 

Attention (AT) commands. 

D.1 Opening a Modem Port

1

Download putty.exe (Putty shareware) from the Internet and install it on a laptop. 

2

Connect the laptop’s Ethernet port to a LAN port on the EN-4000 router.

3

Enable DHCP client mode on the laptop. 

❖

This laptop will request its IP address from the EN-4000.

4

Connect power to the EN-4000 router. Wait for a minute.

❖

This EN-4000 assigns an IP address to the laptop.

5

Open an Internet browser, and type the EN-4000’s LAN IP address 

(

192.168.10.1

) in the browser's address bar. 

❖

If the connection is good, you will see Encore Networks' logo and the login 

prompt.

6

Use the credentials to log into the EN-4000 from the browser. 

Note: 

For EN-4000™ routers, the default login name (or user name) is 

root

. 

(For all other EN™ routers, the default user name is 

admin

.) In addition: 

• Devices shipped before July 09, 2018, use the default password 

encore!1

. 

• Devices shipped from the factory on or after July 09, 2018, use a randomly 

generated default password. That password is contained in information on a 

sticker on the bottom of the router's chassis. Retain that sticker; you will need 

that default password if the router must be reset. (For details, see the 

document 

Password Policy for EN™ Routers

.) 

T

EN-4000™ Reference Manual

Document D

Version A.2, September 2019

© 2019 Encore Networks, Inc.

All rights reserved.