Remote Control
1.SOURCE Button
6.EQ Button
12. CLOCK/MO/ST Button
2.Standby Button
7. VOL-(Volume-) Button
13. VOL+ () Button
3. FM SCAN Button
8. BASS- Button
14. BASS+ Button
4. TUNE-Button
9. TREBLE- Button
15. Play/Pause Button
5.M+() Button
10.Mute Button
16. Button
11. TUNE+ Button
BATTERY INSTALLATION
- Before installation
Remove and discard the insulation tab.
-Replace battery for the remote control
1. Push and slide out the battery holder as Figure 1 below.
2. Replace the battery with a new CR2025 button cell with the polarity (+) side upward.
3. Slide into the battery holder.
Battery precautions
• Never recharge the batteries, apply heat to them or take them apart.
• Battery shall not be exposed to excessive heat such as sunshine, ire or the like.
• Do not throw the batteries in ire!
• Attention should be drawn to the environmental aspects of battery disposal.
• If the remote control is not going to be used for a long time, remove the battery
to avoid damage caused by battery leakage corrosion.
3
Summary of Contents for iTrak BT0218GBMO
Page 1: ......
