SSID:
The SSID differentiates one Wireless LAN group name from another; so
all access points and all devices attempting to connect to a specific Wireless LAN
group name must use the same SSID. A device will not be permitted to join the
BSS unless it can provide the unique SSID.
Wireless Mode:
If you want to connect with an Access Point/WLAN Router,
please set to “Infrastructure” mode. If you have more stations and just want to set
them as local network, please set the mode to “Ad-hoc” mode.
Channel:
It shows
auto
that used for Infrastructure Wireless LAN network. The
channel number can be set only under the Ad-Hoc operation mode. In Ad-Hoc
mode stations, each station must have the same channel number and SSID.
In Infrastructure mode, the Wireless USB Adapter will automatically detect the
channel number of the Access Point.
Power Mode:
There are 3 modes to choose:
Continuous Access Mode (default)
: The USB Dongle is constantly operating
with full power and it consumes the most power.
Maximum Power Save
: The USB Dongle consumes the least power and only
operates when there is wireless network activity.
Power Save
: The USB Dongle consumes the moderate level of power.
Preamble:
Select Long or Short/Long (auto) Preamble type. Preamble is a
sequence of bits transmitted at 1Mbps that allows the PHY circuitry to reach
steady-state demodulation and synchronization of bit clock and frame start. Two
different preambles and headers are defined: the mandatory supported Long
Preamble and header, which interoperates with the 1 Mbit/s and 2 Mbit/s DSSS
