6
7
UNPACK THE
ROLLSROLLER ENTRY
NOTE
■
Be careful while unpacking the
ROLLSROLLER Entry to avoid
damaging any parts.
■
NOTE THAT YOU NEED LONG
FORKS
minimum 1800 mm/
5ft. 11in.
■
DO NOT walk under the hanging
goods
1. ROLLSROLLER Entry crated.
2. Use a metal shear to cut the steel bands.
3. Loosen the screws that seal the crate.
5. Remove the screws holding the side cover.
6. Remove the side cover.
4. Remove the top cover.
7. Remove the steel bands holding the ROLLSROLLER Entry in place (see left & right picture).
Then cut the straps holding the legs (see right picture).
1. Lift the flatbed out of the crate with a forklift or by hand. Left picture illustrates where to lift the flatbed by hand. The
right picture illustrates where to put the forks when lifted by forklift.
FOR THIS STEP YOU WILL NEED
■
Metal shear
■
Screwdriver
■
Box cutter/scissors
FOLD OUT
THE LEGS
NOTE
■
Important. Lift the flatbed
horizontally out of the crate.
Otherwise damage can occu-
re to the flatbed or the parts
included in the crate.
■
Never turn the table upside
down.
■
If lifted with forklift, note
that long forks must be used
(minimum 1800 mm / 5ft.
11in.).
■
Do not walk under the hang-
ing goods
2. When the flatbed is lifted the legs will be foulded
down by gravity.
3. Before puting down the flatbed make sure the pins
locks in it’s right position (see picture above).
4. When the pin is in its right position lock the bolt
to secure the leg’s stability (use a 19mm spanner or
the spanner included).
