14
Owners manual: model 5515 outdoor patio heater 06-01-2010
16 mm
19mm
3. OPERATION
Caution:
Do Not attempt to operate the heater until you have read and understood the warnings section in this manual.
MOUNT THE HEATER ON THE GROUND FIRST!
3.1 TURNING THE GAS SUPPLY ON
CONNECT THE GAS HOSE AND REGULATOR ASSEMBLY TO THE TANK
Note:
Use only a Department of Transportation (DOT) approved 20 pound cylinder with an ACME/ Type 1 connection
with QCC (Quick Connect Coupler)safety valves. When the Cylinder is empty it should wheight 18 pounds.
CHECK FOR LEAKS:
Make a solution of 2-3 oz. of leak checking solution by mixing
one part liquid dishwashing soap and three parts water.
Follow the procedure below:
LEAK CHECKING FUEL TUBE CONNECTION
Step 1: Turn cylinder valve on by turning anti-clockwise.
Step 2: Check fuel tube connection for leaks.
To check for leaks spoon several drops of solution onto the connections as illustrated.
Step 3: Inspect the solution for bubbles. If no bubbles appear then the connection is secure.
If bubbles appear, then there is a leak: Turn OFF the cylinder valve.
Undo the connection and inspect the surface of the cone to make sure they are clean.
Reconnect by using two wrenches, one on either side of the connection.
Repeat the leak checking procedure described above.
If you still see bubbles after several attempts
DO NOT USE THE HEATER.
Contact service for assistance.
5515_USA_RATTAN_060110.indd 14
07.01.10 10:27
