Fastlane
®
Pro Swim Unit Installation
4.B. Steel/Polymer Pool with a Vinyl Liner
If the pool being constructed is a steel or polymer pool with a vinyl liner, please follow
the instructions below.
The Wall Mount Fastlane Pro Mounting Kit for steel/polymer/gunite pools with a vinyl
liner includes the following:
(1) PVC Wall Bracket
(2) Bonding Clamp
(2) 3/8" (9,5mm) Stainless Steel Threaded Mounting Rod
(2) 3/8" (9,5mm) Stainless Steel Coupler
(2) 3/8" (9,5mm) Stainless Steel Threaded Stud
(4) 3/8" (9,5mm) Stainless Steel Jam Nut
(2) 3/8" (9,5mm) Stainless Steel Flat Washer
(2) 3/8" (9,5mm) Stainless Steel Lock Washer
(2) 3/8" (9,5mm) Rubber Washer
(2) 3/8" (9,5mm) Stainless Steel with Neoprene (Sacrificial Washer)
(2) 3/8" (9,5mm) Stainless Steel Hex Head Bolt (Sacrificial Bolt)
(2) 1-1/2" (38mm) Star Thru-Wall Fitting
(2) 1-1/2" (38mm) MPT x FSlip Adapter
(2) 1-1/2" (38mm) MPT x 1” (25mm) FPT Bushing Reducer
(2) 1" (25mm) Liquid Tight Fitting
(1) Clear Silicone
Position the PVC template where the Fastlane Pro will attach to the pool wall and align the bottom of the
template with the expected water level in the pool (which will typically be located at the centerline of the
skimmer) as shown in Figure 4.6. Use duct tape to temporarily adhere the PVC template to the pool wall.
Be certain that the PVC template is level in the pool. Trace the outline of the star thru-wall fittings and
threaded rod hole penetrations that are cut in the PVC template onto the pool wall. Remove the PVC tem-
plate from the pool wall. Cut or punch the openings for the star thru-wall fittings and threaded rod holes.
Fig. 4.6
13
