Fastlane
®
Pro Swim Unit Installation
9.3 This next step is best done with two people. Carefully lower the Fastlane Pro into the pool. Align the
holes in the bracket with the holes in the hose cover tray. Use the provided 1/2" (12,7mm) screws to
attach the top screws first and then the vertical screws next (total of 8 screws) (Fig 9.3).
Fig. 9.3
9.4 Run the hydraulic hoses up and out of the pool and into the hose cover tray. Place the hoses under the
hose clip (see Fig 8.2). Pull any excess hose out of the pool and out of the hose cover tray. Once the
hoses are in the hose clip, secure the clip to the tray.
9.5
Secure the stainless steel bond wire (that exits the top of the Fastlane Pro) to the bond lug at-
tached to the hose cover tray. Attach a #8 AWG bare copper wire to the bonding lug (attached to
the hose cover tray) and then incorporate that wire into the pool’s bonding grid.
9.6 Place the Fastlane Pro lid onto the top of the Fastlane Pro and use the six 3/4" (19mm) stainless steel
screws that were provided (3 on each side) (See Fig 6.12).
9.7 Place the hose cover onto the hose tray and use the provided 1/2" (12,7mm) stainless steel screws to
attach the cover to the tray (Fig 9.4).
9.8 If the distance between the Fastlane Pro and Power Unit is 25' (7,6m) or less, then the hoses attached
to the Fastlane Pro will connect directly to the Power Unit (see section 12). If the distance between the
Fastlane Pro and Power Unit is greater than 25' (7,6m), then additional run hoses will be required. Use
the adapters provided with the hydraulic run hose to connect the hoses attached to the Fastlane Pro and
the additional run hose.
Fig. 9.4
37
