Magical Balancer
4
Installation of Magical Balancer
22
4-2
Installation procedures
DANGER
A wire rope is packed together with the Magical Balancer. Be sure to attach the
wire rope to the hanger of the balancer.
This is necessary to protect workers if the top hook or support members (metal
hangers) of the Magical Balancer are damaged.
For support members to attach (suspend) the Magical Balancer, use members that
have a sufficient safety coefficient for supporting the mass (weight) and the
maximum capacity of the Magical Balancer.
Do not use support members that cause the Magical Balancer to tilt toward one
direction.
Adjust the length of the auxiliary wire rope so that the dropping distance of the
main equipment can be limited to 100 mm.
4-2-1 Installation
Note: The numbers in brackets in the procedures are the reference numbers of the Parts List.
1
Use the top hook (accessories) or the trolley (options) to attach the Magical Balancer to the
support members.
•
For the method of attaching the top hook, refer to “4-3 Attachment of the upper hook”.
•
For the method of attaching the trolley, refer to “4-4 Attachment of trolley”.
2
If the upper hook is attached, ensure that the top hook is correctly attached to the support
members and the hook latch is correctly closed.
3
Attach the auxiliary wire rope as shown in the following outline.
1)
Pass wire rope (7) through the hole of the hanger, and wind the wire rope around the
head supporting section.
2)
Adjust the length of the end of wire rope (7).
3)
Use wire clip (8) to securely clamp the wire rope.
4)
Tighten the nut of wire clip (8) with a torque of 10 N·m.
