Magical Balancer
4
Installation of Magical Balancer
25
4-5
Piping of the air hose
WARNING
Maintain the air supply pressure below 0.7 MPa.
The Magical Balancer is designed to be operated within the air supply pressure
range below 0.7 MPa. If the air supply pressure exceeds 0.7 MPa, use a regulator
to reduce the pressure to the required air supply pressure.
CAUTION
Do not use a lubricator (oiler) for the air supply line of the Magical Balancer.
Do not use any type of lubricating oil, because it may cause a malfunction in the
control module as well as damage to the internal parts.
Be sure to install a filter and a regulator.
1
Check whether a sufficient amount of air can be supplied to the operating position of the
Magical Balancer.
If the pipe diameter is too small or the piping distance is too long, the pressure drop may be
so significant that the product cannot exhibit its intended performance.
2
Use an air hose with an inner diameter of 9.5 mm (3/8 in.) or greater.
3
Air-blow the air hose and the pipes before connecting them to the Magical Balancer.
This prevents foreign objects from entering the control module or the cylinder.
4
The compressed air supplied to the Magical Balancer must not contain moisture or foreign
objects (dust particles). Install an air filter to separate them.
5
Provide a drain circuit at the lowest point of the piping.
