Burford Outdoor Post Light
Safety Warnings
INSTRUCTION MANUAL
• This product is only suitable for connection to 240V~50Hz supply. It is recommended that this light is
installed by a qualified electrician in accordance with current IEE Wiring Regulations and local Building
Regulations
• Before installing your light fitting always switch off the mains supply and remove the appropriate fuse or
switch off the appropriate circuit breaker before commencing installation.
• This is a Class I fitting, and
must be connected to Earth.
The terminal blocks are supplied according to
requirements of the fitting.
• Run supply wire from a 5-amp electrical supply using double insulated 3-core cable of type H05RN-F
1.0mm2 (not supplied) to selected site, ensuring it is adequately protected through the full length of the
cable run, it must come out of the flat surface of the mounting surface in line with the entry to the fitting.
• Except where installed in a conduit or duct , which provides equivalent protection against mechanical
damage, a cable buried in the ground shall incorporate an earthed armour or metal sheath or both, suitable
for use as a protective conductor, or be of insulated concentric construction. Buried cables shall be marked
by cable covers or a suitable marking tape. Buried conduits and ducts shall be suitably identified. Buried
cables, conduits and ducts shall be at a sufficient depth to avoid being damaged by any reasonably
foreseeable disturbance of the ground.
• Never fit bulbs of a higher wattage than those specified on the label (as these may cause overheating and
damage the fitting).
• This product contains delicate parts. Take care during installation and maintenance to avoid breakages
• If you are in any doubt about your competence please consult a qualified electrician.
• If any modification is made it will invalidate the warranty and may render the product unsafe.
• This product must only be installed to a solid, fixed surface, such as concrete, decking or paving slabs. It
must
NOT
be installed on soil.
Endon Lighting, LS9 0SE
Assembly/ User Instructions
Please read these instructions carefully before fitting and retain for reference.
Check the packaging and make sure that you have all the required parts.
Follow each assembly step in order to prevent incorrect assembly.
Ensure that the product is fully assembled as illustrated before use.
The Light pack contains:
Light fitting.
Terminal connection block(s).
Fixing pack.
6 x Glass panels
The following tools may be required:
Selection of cross and flat head screwdrivers.
Electric drill and assorted drill bits.
Wire strippers.
Electrical insulation tape.
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.
Before you start
Care Information
Allow 10 minutes to cool before replacing, adjusting or cleaning.
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.
76549-Burford-Post 20181127
