1
The Light pack contains:
Recessed light and retaining clips.
Driver with terminal connections.
The following tools may be required:
Selection of cross and flat head screwdrivers.
Electric drill and assorted drill bits.
Wire strippers.
Electrical insulation tape.
INSTRUCTION MANUAL
This product is only suitable for connection to a 240V~50Hz supply in accordance with current IEE
wiring Regulations and should be installed in accordance with National Building Regulations and is
for Domestic use only. It should be mounted out of arms reach – for indoor ceiling use only - and is
not suitable for a Bathroom location.
The light fitting should be connected to a lighting circuit protected by a 5 amp fuse (or a 6 amp
miniature circuit breaker).
If in doubt we recommend you contact a qualified electrician. Before installing your light fitting
always:
Switch off the mains supply and remove the appropriate fuse or switch off the appropriate circuit
breaker before commencing installation.
Ensure that no one else has access that would enable the supply to be inadvertently reconnected.
We recommend that you do not stare directly into the light beam.
This recessed light uses none-replaceable LED`s.
This product contains glass parts – be careful during handling and maintenance to avoid breakage.
The fitting becomes hot during use so please switch off and allow 10 minutes to cool before
repositioning the spot head or cleaning the fitting.
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.
Under no circumstances must the driver be removed and the recessed light connected directly to
the mains – this will cause a safety hazard.
The following symbol indicates that this product must not be covered with thermally
insulating material.
The “Minimum Distance” Label on the product – typical format shown below – indicates that lighted
objects should not be placed within the distance stipulated on the label. The example label below
indicates that lighted objects should not be placed with 0.5m (50cm) of the spotlight to prevent them
overheating
.
If any modification is made it will invalidate the warranty and may render the product unsafe.
Before you start
Please read these instructions carefully before fitting your new light and retain for reference.
Make sure that there are no pipes or cables beneath the mounting surface.
Check the packaging and make sure that you have all the required parts.
Follow each assembly step in order to prevent incorrect assembly.
Make sure all screws / nuts, including electrical connections etc are fully tightened before use.
This type of Light Fitting
must not
be connected to a Dimmer.
EL-10092
Safety Warnings
0.5m
