Endon Lighting Ltd
Leeds
UK
LS9 0SE
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.
.
Assembly / user instructions
N210 102v1
Diagram A
Diagram B
Diagram C
1.
Diagram A.
Remove the back plate by undoing the 2
decorative nuts from the threaded bolts. Unscrew the
glass cover. Secure the 2 sections of the shade onto
the lamp holder housing with the screws provided.
2.
Diagram B
. Fit the 2 threaded posts in the back plate
and bring the mains cable through the rubber
grommet then use the back plate as a template and
mark the 2 fixings holes, making sure the back plate
is correctly aligned so that the threaded bolts are
horizontal. Use appropriate fixings to secure the back
plate to the wall.
3.
Diagram C
. Connect the house wiring to the internal
terminal block. The cable entry grommet must be
securely in place to ensure that the water ingress
protection is maintained.
NOTE:
This is a Class I
fitting and
must be earthed.
Connect the incoming
mains as per the diagram.
4. Diagram D.
Fit the terminal block onto the post in the
back plate and then fit the front frame over the 2
threaded bolts in the back plate and secure with the 2
decorative nuts. Take care not to trap or strain the
internal cables.
5.
Fit the appropriate bulb into the lamp holder
NOTE:
Never fit bulbs of a higher wattage than those
specified on the label (as these may cause
overheating and damage the fitting).
6.
Fit the glass cover making sure any seals are
replaced.
7. Turn on the power and test.
Diagram D
Fixing screws
Threaded bolts
Terminal post
Decorative nuts
Glass cover
