Endon Lighting
LS9 0SE
20150810
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.
The
twin light has been shown here but the same general instruction applies to the single light version.
Assembly / user instructions
N210 116
Diagram A
Diagram B
Diagram C
1. Determine the position of your light
fitting taking into account the exit
position of the cable. Ensure that the
mounting surface is solid, preferably a
brick or block wall and ensure that
there are no other cables or pipes
beneath the surface. Use appropriate
fixings. Wall plugs and screws as
supplied are shown here.
2.
Diagram A
.
Separate the plastic back
plate from the fitting by removing the
two domed nuts / washers (1) on the
front of the fitting. Leave the threaded
(2) bolts in the back plate.
3.
Diagram B
. The internal terminal block
(3) can be removed from its mounting
position inside the back plate to ease
fitment of the back plate. Use the back
plate as a template to mark the screw
holes. Make sure the back plate is
correctly aligned with the drain hole (4)
at the lowest position. NOTE: The
GU10 bulbs will be fitted on receipt but
at times of replacement, the bulb cover
end caps (5) need to be unscrewed
and then the bulbs removed / fitted.
4.
Use a sharp object such as a
screwdriver to pierce the rubber
grommet in the back plate. Feed the
incoming cable (6) through the rubber
grommet and attach the back plate to
the wall. Do not over tighten as this
could damage the back plate.
5.
Connect the house wiring to the
internal terminal block (3).
NOTE:
This
is a Class I fitting and
must be
earthed.
See wiring details.
6. Diagram C.
Place the fitting over the
back plate, ensuring that the bolts in
the back plate are aligned with the
holes in the front of the fitting. Replace
the domed nuts / washers (1) to secure
the fitting. Do not over tighten. Fit the
bulbs (7) (supplied) into the lamp
holders – see NOTE in 3 above.
NOTE:
Never fit bulbs of a higher
wattage or of a type other than those
specified on the label (as these may
cause overheating and damage the
fitting).
7.
Fit the bulb covers (5).
8. Turn on the power and test.
