1.
Diagram A.
Determine the
position of your light fitting.
Ensure there is sufficient power
cable to connect to the fitting –
we recommend at least 250mm.
Ensure that the mounting surface
is solid. If you are using anchor
bolts (not supplied) prepare the
mounting surface as appropriate
(and ensure that there are no
other cables or pipes beneath the
surface).
2.
Diagram B.
Remove the 4 `base`
retaining screws (1) – retain for
re-use.
3. Remove the base plates (2) and
place over the cable and use as a
template to mark the mounting
hole positions. Drill and plug the
holes ready to mount the fitting
later.
4. Pull the terminal block assembly
(3) out of the base of the fitting.
Take the lid off the terminal block
housing to expose the internal
terminal block (4).
5.
C
onnect the house wiring to the
internal terminal block.
NOTE:
This is a Class I fitting and
must be earthed.
Connect the
incoming mains as per the
WIRING DETAILS
diagram
6.
Re-fit the terminal block into its
housing and secure – ensuring
that all seals are correctly
located.
7.
Push the terminal block assembly
as far into the base / stem as
possible.
8.
Secure the post (screws / bolts
etc not supplied) to the mounting
surface making sure that all
cables are contained inside the
fitting.
9. Re-fit the base onto the side
panels with the screws removed
in 2 above.
10. Turn on the power and test.
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.
Assembly / user instructions
Endon Lighting Ltd
Leeds
UK
LS9 0SE
U130 101
Diagram A
Diagram B
WIRING DETAILS
