56232_v2 20200224
LS9 0SE
YG-7501 Grant Wall light Fitting
Safety Warnings
INSTRUCTION MANUAL
• This product is only suitable for connection to a 240V~50Hz supply in accordance with current IEE wiring
regulations. It should be installed in accordance with local building regulations and is for domestic use only.
•
Before commencing installation of your light fitting always switch off the mains supply and remove the
appropriate fuse or switch off the appropriate circuit breaker.
• This is a Class I product, and
must
be Earthed. The terminal blocks are supplied according to requirements
of the fitting.
• Run supply wire from a 5-amp electrical supply protected by an RCD using double insulated 3-core cable
of type H05RN-F 1.0mm2 (not supplied) to selected site, ensuring it is adequately protected through the full
length of the cable run, it must come out of the flat surface of the wall or steps in line with the entry to the
fitting.
• Except where installed in a conduit or duct which provides equivalent protection against mechanical damage,
a cable buried in the ground shall incorporate an earthed armour or metal sheath or both, suitable for use as
a protective conductor, or be of insulated concentric construction. Buried cables shall be marked by cable
covers or a suitable marking tape. Buried conduits and ducts shall be suitably identified. Buried cables,
conduits and ducts shall be at a sufficient depth to avoid being damaged by any reasonably foreseeable
disturbance of the ground.
•
Never fit bulbs of a higher wattage than those specified on the label, as these may cause overheating and
damage the fitting.
• This product is suitable for outdoor use, has special protection against the ingress of water, and is rated IP44.
•
If you are in any doubt about your competence please consult a qualified electrician.
•
If any modification is made it will invalidate the warranty and may render the product unsafe.
• If any part of the glass is broken or cracked then it must be replaced immiediately to preserve the water
ingress protection.
Assembly/ User Instructions
Before you start
Please read these instructions carefully before fitting and retain for reference. Check the packaging and make
sure that you have all the required parts. Follow each assembly step in order to prevent incorrect assembly.
Ensure that the product is fully assembled as illustrated before use.
DO NOT CONNECT THIS PRODUCT TO A DIMMER SWITCH / EXTERNAL PIR UNIT.
The Light pack contains:
Light fitting.
Terminal connection block.
Fixing pack.
The following tools may be required:
Selection of cross and flat head screwdrivers.
Electric drill and assorted drill bits.
Wire strippers.
Electrical insulation tape.
Care Information
Allow 10 minutes to cool before replacing, adjusting or cleaning.
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.
1.
Decide on the position of the light fitting, or remove existing light fitting. Note the position of the electrical
connections. Ensure there is a solid mounting surface, preferably a brick wall, to support the weight of the
light fitting.
2.
Remove the fixing bracket, by undoing the 2 top screws (1), retain these for re-use.
3.
Use the fixing bracket as a template to mark the screw holes(2), and secure to the wall with appropriate
screw fixings (3), making sure the bracket is vertical. Take care to avoid damaging any concealed wiring or
pipes.
4.
Support your fitting and connect the house wiring to the terminal block. The cable entry grommets must be
