1
The Light pack contains:
Light fitting and mounting bracket.
Terminal connection block(s).
The following tools may be required:
Selection of cross and flat head screwdrivers.
Electric drill and assorted drill bits.
Wire strippers.
Electrical insulation tape.
INSTRUCTION MANUAL
This product DOES NOT have special protection against the ingress of water. It is ONLY
suitable for use in porches if it is not exposed to water ingress.
This product is only suitable for connection to a 240V~50Hz supply in accordance with current IEE
wiring Regulations and should be installed in accordance with local Building Regulations and is for
Domestic indoor ceiling use only and is not suitable for a Bathroom location.
The light fitting should be connected to a lighting circuit protected by a 5 amp fuse (or a 6 amp
miniature circuit breaker).
If in doubt we recommend you contact a qualified electrician. Before installing your light fitting
always:
Switch off the mains supply and remove the appropriate fuse or switch off the appropriate circuit
breaker before commencing installation.
Ensure that no one else has access that would enable the supply to be inadvertently reconnected.
Never fit bulbs of a higher wattage or of a type other than those specified on the label as this may
cause overheating and damage the fitting.
When fixing to the mounting surface ensure that the fixings used are appropriate for the mounting
surface on which they are being used.
The bulbs become hot during use so please switch off and allow 10 minutes to cool before replacing
bulbs or cleaning the fitting.
IMPORTANT: To achieve maximum corrosion resistance the surface of the Stainless Steel must be
kept clean. Surface contamination and the formation of deposits are critical factors which may lead
to drastically reduced life. An example is salt deposits from marine conditions. Careful cleaning with
soap or a mild detergent and warm water followed by a clean water rinse and finally wiping dry is
usually adequate for most S/S items used in the domestic environment. Care must be taken to turn
off the mains supply until the cleaning process has been completed and the fitting is completely dry.
If any modification is made it will invalidate the warranty and may render the product unsafe.
Before you start
Please read these instructions carefully before fitting your new light and retain for reference.
Make sure that there are no pipes or cables beneath the mounting surface.
Check the packaging and make sure that you have all the required parts.
Follow each assembly step in order to prevent incorrect assembly.
Make sure all screws / nuts, including electrical connections etc are fully tightened before use.
This type of Light Fitting may be connected to a Dimmer if a Tungsten incandescent bulb is used. If
a CFL type bulb is fitted then these cannot (generally) be controlled by a dimmer.
YG-865-SS – Single pendant
Safety Warnings
