4
The Endorphin
e
1-
MAG
resistance system is designed to be accessible, easy-to-use, and allows
the user to train independently. Tried, tested, and proven in rehab facilities and homes, the
Endorphin
e
1-
MAG
resistance system delivers excellent upper-extremity muscle conditioning and
improves cardiovascular capacity. A bi-directional magnetic resistance flywheel design means
less noise and a frictionless resistance versus traditional friction belt-type hand cycles. A multi-
function electronic monitor which reads distance, time, speed, calories, and pulse. Comfort grip
handles are provided to allow the user to rotate his arms forward and reverse. The bi-
directional flywheel on the
e
1-
MAG
allows the user to exercise with resistance in both the forward
and reverse directions. The adjustable magnetic resistance features 8 workload levels, which
allows the user to have smaller resistance changes.
INSTRUCTIONS:
1. Hand
Grips
: The handgrips are clearly marked at the threaded end of the grip, L for left
and R for right. Install the L grip into the hand crank on the left-hand side of the cycle.
Turn it counter clockwise to tighten. Install the R grip into the hand crank on the right
side of the cycle. Turn it clockwise to tighten. A small adjustable wrench should be
used to securely tighten the grips into the hand crank. The handles should rotate freely
on the threaded rods. In the 370 Series platform format the handles may have been
attached at the factory.
2. Electronic Exercise Monitor
: Our flexible power system allows the unit to operate
using batteries or with a power adaptor provided. Secure the monitor on the monitor
bracket and connect the control and sensor cables.
Option 1: Install the batteries into the monitor as described in the monitor instructions
(located in the parts box with the monitor).
Option 2: The unit may also be powered with the adaptor provided. Note: Please
remove the batteries if installed then plug the adaptor cable into the back of the monitor
then plug the adaptor in to the wall (120V). Plug-in the Ear Clip into the front of the
meter if required. Ensure that the Ear Clip cable does not get caught in the hand crank
when it is rotated.
3. Resistance Adjustment
: Please follow the operating instructions provided with the
electronic monitor (located in the box covering the monitor)
4. Power
Supply
: The AC adapter 6VDC monitor and servo power supply requires a 120V
60Hz 25W outlet. We recommend that you use a surge protector type plug and then
plug that into the outlet.
5. Exercise
: Adjust the resistance with the adjustment lever and start the electronic meter.
Take hold of the handles and begin to rotate them in a forward or reverse motion. The
resistance may feel harder at the start but will become less as the flywheel builds up
momentum.
