9
Care & Maintenance:
The
e
4
resistance system should never need grease on the bearings located inside the bearing
housing. However, periodic adjustment and lubrication of the chain may be necessary.
Loosening the lock nut, located on the either side of the flywheel axle can make adjustments.
Please call 1-800- 940-9844 for all customer service, warranty, and product information.
FAQ’s & Trouble Shooting:
Problem:
The handgrips will not attach to the hand crank.
Answer:
1. Check that you have a left and a right hand grip, not two lefts or two rights.
Marked L and R at threaded end of the bolt.
2. Then check that you are trying to attach the right hand grip to the right side
and that you are rotating the handgrip in the correct direction.
3. Check that the threads have not been cross-threaded.
Problem:
The handgrips unscrew from the hand crank when rotated.
Answer:
1. Check that the handgrips are secured in position using a wrench and are not
just hand tight.
2. Ensure that the rubber handgrip rotates on the threaded shaft. If not please
return the part to your supplier for a replacement.
Problem:
When the handles are rotated the chain does not engage the flywheel.
Answer:
Check that the flywheel axle has not moved, loosen the axle nuts and pull the
flywheel forward. Then secure the axle nuts.
Problem:
There is a loud rubbing sound when the handgrips are rotated.
Answer:
It is possible that during shipping the flywheel axle vibrated loose. This would
cause the drive belt to either become loose or come off the pulley. Remove the
cover, pull the flywheel axle until the belt is taught and straight, and then secure
the axle in place with a wrench.
Problem:
The flywheel resistance is too light or too heavy.
Answer:
See the resistance adjustment instructions on page 3, #5.
Problem:
Electronic monitor will not turn on.
Answer:
Check all power connections. Ensure the 6VDC power supply plug is inserted
correctly into the plug and the cable is not over extended. Check that the colored
ribbon cable is properly inserted into the back of the monitor. Read monitor
instructions again to ensure correct operating procedure. All units are tried and
tested before shipping.