English ·
1
Installation and use
◗
Operating the Akkulift
®
in the bath
1. Before starting up your Akkulift
®
, make sure
that the battery is inserted in the battery com-
partment and the hand control is correctly con-
nected (plug-type connection – see figure).
Press the ON-button at the hand control. The
green lamp is illuminated.
2. Press the orange key (“UP”-button). The
backrest is moved into an upright position first;
then the lift raises to its end position and swit-
ches off automatically. When the button is re-
leased, the lift is stopped, thus making it possi-
ble to move to intermediate stop positions.
3. Fold out the side flaps until they rest on the
sides of the bathtub.
4. If the bathtub is too tall to allow side flaps to lay
flat then you can use available height adapters
(purchase separately) to raise your lift to the
proper height. Height adapters
must not
be
used
without
suction cups.
5. Help the disabled person to sit down on Akku-
lift
®
.
6. To lower Akkulift
®
, press the blue key (“DOWN”-
button). The lift lowers until it reaches its end
position and switches off automatically. When
the button is released, the lift is stopped, ma-
king it possible to move to intermediate stop
positions.
➤
Attention: Release the blue button imme-
diately if the backrest is pushed against
the wall of the bathtub!
In case of an emergency, press the red
button on the hand control. Then all move-
ments come to a halt. To reset you have
to press the “ON”-button again!
Akkulift
®
with height adapters (optional)
