1
· English
7. After bathing, press the orange key (“UP”-but-
ton) of the hand control in order to raise the lift
back to a convenient height (the max. position
is the upper stop position).
Make sure that the side flaps do not get
caught at any bathtub fittings or handles.
8. Help the disabled person to leave the bathtub.
The bath lift switches off automatically after
approx. 30 minutes, but if you want to switch it
off manually then use the red button (LED is then
off).
➤
Note:
When moving up or down, the disabled per-
son should lean back against the backrest
and put his or her hands on the lap.
If the lift is to remain inside the bathtub,
then remove the battery from the battery
compartment. This will prevent unintended
discharging of the storage battery.
Installation and use
◗
Removing the lift from the bathtub
Using the hand control, first lower Akkulift
®
to its
lowest position. Tilt back the backrest until the
drive stops automatically in its end position. Make
sure that the backrest does not push against the
wall of the bathtub.
Then remove the battery
from the battery compartment.
1. The backrest is unlocked by pressing the un-
lock button on the top of the backrest down-
wards (figure).
2. Then fold down the backrest while keeping the
button pressed and simultaneously folding the
backrest towards the seat until it rests on the
seat (figure). Use the provided handle.
≈
