HS 55 (Batch Mode)
Transport and storage
45
8
Transport and storage
8.1
Transport
When transporting the device, observe the safety instructions in the "Safety instructions"
section.
Avoid the following during transport:
¡
Impact and vibration
Risk of damage due to shock, impact or vibration!
¡
Large temperature fluctuations
Risk of condensation!
8.1.1
Preparing the device for transport
CAUTION
Dangerous voltage at the cell heating connection
Dangerous voltage may be present at the cell heating connection.
¡
Only disconnect electrical connection cables between the system components when
the system is switched off. Otherwise the sensitive electronics may also get dam-
aged.
CAUTION
Risk of chemical burns
The reduction agent solution contains sodium borohydride and sodium hydroxide and is
corrosive.
¡
Wear protective goggles and protective clothing when handling the corrosive solu-
tion.
¡
Observe all instructions and specifications in the safety data sheets.
¡
Neutralize the basic solution and dispose of it professionally.
¡
Also be careful when handling hoses. They can contain residues of the corrosive so-
lution.
}
Exit the control and analysis software and clean the system.
ü
The Hg/hydride system flushes the hoses with distilled water and pumps them
out after removal from the flushing solution.
}
Relieve the pump hose by releasing the hose cartridge.
}
Switch off the Hg/hydride system and the AAS. Disconnect the power cable from the
socket.
}
Disconnect all connection cables to the AAS and the cell unit.
}
Allow the cell unit to cool down.
CAUTION! Risk of burns at the cell unit!
}
Disconnect the cell hose that connects the Hg/hydride system to the cell unit in the
AAS.
