Changing number of bottles
The sampler can operate using a composite container or can distribute the
samples into a number of discrete bottles using a sample distribution system.
Changing from one form of distribution to another can be done by simply
exchanging one form for another.
Changing from composite
container to distribution
1. Disconnect temperature
sensor from A.
(Reason: there is a temperature
sensor built into the distribution tray).
2. Remove the composite
container and replace with
new bottle tray (first remove
the bottle lids).
3. Push distribution tray in
using the guides and plug in
cable A.
4. Make sure that the sample
outlet hose fits into the
distribution tap C (lower picture).
Changing from sample
distribution system to
composite container
1. Remove bottle tray.
2. Unplug distribution tray
cable from A and replace
tray with the composite
container
3. Plug in temperature sensor
into A. This can be
purchased as an accessory.
(order No. 50069496).
Changing to other distribution
types
1. Unplug distribution tray cable from A.
2. Remove bottle tray and distribution system and replace with new
system. Then connect cable to A.
4. Make sure that the sample outlet hose B is placed inside the
distribution tap C.
a) Only use "bottles/bottle tray/distribution" that belong to each other.
b) 4x10l system operates with single bottles and no distribution tray.
c) Do not forget to remove the bottle lids.
C
A
asp-station d 2
Umbau, Probenverteilung
37
